Carry out the following tasks:
- Log on to the Interactive Interface
To install High Level Assembler using the Interactive Interface, log on to
the z/VSE Interactive Interface as the system administrator.
For more information about the functions of the
Interactive Interface, refer to z/VSE: Guide to System Functions.
In the following menus
enter the highlighted items that appear after the
===> symbol.
- Mount the High Level Assembler tape on an available tape drive.
- In the z/VSE FUNCTION SELECTION menu, select:
===> 1 (Installation)
- In the INSTALLATION menu:
You received High Level Assembler as a V2 Format tape, which contains
one or more optional products, select:
===> 2 (Install Programs - V1 Format)
- In the INSTALL PROGRAMS - V1 FORMAT menu select:
===> HLASM......1.6.0 (Tapefile-id)
If you did not use the default library PRD1.BASE, enter the
name of your library and sublibrary on this screen. The DLBL
and EXTENT information for this library should already be
in the label information area.
Press PF5 to generate the installation job.
- In the INSTALL ADDITIONAL PROGRAM(S) FROM TAPE menu, enter:
===> cuu
(the address of the tape drive where you mounted the
High Level Assembler tape)
(If you are using a virtual tape, enter 1 for Virtual Tape,
otherwise enter 2.)
- In the JOB DISPOSITION menu:
Make any changes required and
press Enter to submit the job to install High Level Assembler.
- Respond to console messages
Confirm prompt when asking for tape to install product.