Installation step 15: Tailor the DB2 catalog: DSNTIJTC

Job DSNTIJTC invokes the CATMAINT utility to tailor your DB2® 10 catalog, which you must do to fully install DB2. DSNTIJTC performs site-specific tailoring of the catalog.

Before you begin

To execute DSNTIJTC, you must have the installation SYSADM authority. Start of changeAlso, SMS must be active on the system where this DB2 subsystem is being installed. SMS must be configured to allocate all data sets for the DB2 catalog and directory in extended format and to use extended addressability.End of change

About this task

Important: In a data sharing environment, do not run DSNTIJTC after installing non-originating members.

Procedure

To tailor the DB2 catalog:

Run job DSNTIJTC. You must ensure that the installation job runs on the same z/OS® system on which the appropriate DB2 subsystem is running.

A status message, DSNU777I, is issued at several points to indicate progress. Diagnostic error messages are issued when CATMAINT processing fails. If a problem is found during the SQL processing phase of installation, message DSNU778I is issued. If non-supported functions are encountered, message DSNU776I is issued. All of these messages are written to the SYSPRINT data set.

Because this is the first use of DB2, errors from earlier steps might be detected here.

Results

Start of changeIf you receive abend reason code 00C200EF, the catalog and directory data sets are not in a compliant SMS environment.End of change

Start of changeIf you receive an abend reason code from the data manager (X'00C9'xxxx) or buffer manager (X'00C2'xxxx), carefully recheck jobs DSNTIJIN, DSNTIJID, DSNTIJIE, and DSNTIJIF.End of change