DSNT716E   AN ERROR OCCURRED ESTABLISHING A RESOURCE LIMIT FOR CORRELATION-ID correlation-id, CONNECTION-ID connection-id, LUW-ID luw-id =token. limit WILL BE USED AS THE LIMIT

Explanation

An internal error occurred while the resource limit for the specified requester was being established. The 'limit' is determined from the default specified in the system parameters. This default can be:
NOLIMIT
No limit applies.
NORUN
Zero time limit.
integer
The limit to be used.

A logical-unit-of-work identifier (LUW-ID) of '*' indicates that the thread does not have a LUW-ID. If the LUW-ID is not an '*', the value is a logical-unit-of-work-id that is assigned to the thread followed by an '=' sign and a token value, which can be used in place of logical-unit-of-work-id in any DB2® command that accepts logical-unit-of-work-id as input. Correlation IDs beginning with '0nn', where 'nn' is a number from 01 to 28, identify system agents.

System action

Processing continues using the system-defined default.

Operator response

Notify the system programmer.

System programmer response

If you suspect an error in DB2, you might need to report the problem. For information about identifying and reporting the problem, see Collecting diagnostic data.

Problem determination

Collect the following diagnostic items:
  • Console output from the system on which the job was run, and a listing of the SYSLOG data set for the period of time that spans the failure.
  • Listing of SYS1.LOGREC data set, obtained by executing IFCEREP1.