DSNT710I   table-name ALREADY ACTIVE. START LIMIT COMMAND IGNORED

Explanation

A START RLIMIT command was entered and the governor is already active utilizing the specified table. The command is ignored.

System action

The governor continues to use table 'table-name'.

Operator response

Verify that the ID specified on the START RLIMIT command is the correct ID. If not, reenter the command specifying the correct ID. If it is correct, no action is needed because the facility is already active and is using the correct table.

System programmer response

If you suspect an error in DB2®, you might need to report the problem. For information about identifying and reporting the problem, see Collecting diagnostic data.

User response

See Operator Response.

Problem determination

Collect the following diagnostic items:
  • Console output from the system on which the job was run, and a listing of the SYSLOG data set for the period of time that spans the failure.
  • Listing of SYS1.LOGREC data set, obtained by executing IFCEREP1.