UJP37

A configuration problem occurred.

The problem might be caused by one of the following items:

• Too many active lines are using the same I/O processor (IOP).
• The line speeds are set too high.

To find the lines using the same IOP, perform the following steps:

1. Vary off the failing line (VRYCFG command).
2. Vary the line back on, with the reset option of the VRYCFG command set to Yes.
3. The active lines using that IOP will be displayed with their line speeds. Determine whether there are too many lines using the IOP, or whether the line speeds are set too high. Correct the configuration as needed.

This ends the procedure.