HSL Opticonnect abnormal disconnect from other sys. or partition.
Response
The local system or partition disconnected from a remote
system or partition due to an unexpected event or failure.
All of the HSL OptiConnect connections on this loop will be
in a failed state. LIC will attempt to recover from the
error. Intervention at the local or remote system or
partition may be required. Possible causes are:
time out of a critical message
LIC code / table problem
Network deadlock detected
The problem may be with:
The local system or partition
The remote system or partition
Examine the Service Action Log (SAL), or serviceable
event view you are using, on the local system or
partition for HSL failures on the same HSL loop, or with the
Network Interface Controller at approximately the same time
this error occurred.
Examine the remote system or partition for problems.
Examine the Service Action Log (SAL), or serviceable
event view you are using, on the remote system or
partition for problems on the same HSL loop or with the
Network Interface Controller at approximately the same time
this error occurred.
Correct any problems you find with the remote and local
systems or partitions that happened at approximately the
same time and involve HSL Opticonnect or HSL loop components
or Network Interface Controllers.
If there are no problems with the remote system or partition
and there are no problems with the local system or partition
then collect all the Product Activity Log information for
this failure on all systems or partitions. Be sure to
record all words in the SRCs. Contact your next level of
support.