Multi-adapter Bridge or PCI Bridge configuration change or error.
Response
One of several errors or configuration problems has occurred
under a Multi-adapter Bridge or PCI Bridge. If you are using the
Service Action Log (SAL), or the serviceable event viewer on
the hardware management console or the service processor, then the correct FRU,
description and card position(s)
will be listed. Use the FRUs and descriptions in the
serviceable event view you are working with to determine
the problem.
If you do not have access to the Service Action Log,
or serviceable event view on the hardware management console or service processor,
then
word 4 of the SRC has more information. Examine the last 4
digits in word 4 to determine the problem by comparing them
to the list below and using the FRU(s) listed here.
xxxx2022 - IOP found in slots owned by a Linux
partition. The Multi-adapter Bridge or PCI Bridge and PCI Bridge set that
it controls are assigned to a Linux partition. The IOP
found in the SLOT indicated by the DSA in word 7 will not be
configured.
xxxx2014 - I/O adapters were found under the
Multi-adapter Bridge or PCI Bridge but there is no IOP to support them.
The adapters cannot be used.
xxxx2015 - An card type was found that cannot be
supported in the card position where it is located.
See MABRCFG symbolic FRU for the list of messages, a
further description of the problem detected by Licensed
Internal Code and the corrective action.