You
might need to reset your tape drive. Use the procedure in this topic
to perform this task.
Use this information to reset your tape drive, without affecting
server operation. Allow up to 2 minutes for the entire tape drive
process to complete.
Attention: Resetting a tape drive
before the current backup operation has completed can cause loss of
customer data.
To reset the tape drive, complete the following
steps:
Press and hold the eject button for 20 seconds, and then
release the button. The LEDs on the drive flash while
the reset function is in process.
After the LEDs stop flashing, wait approximately one minute
for the drive to complete the reset operation. The drive
is then ready to use.
Subscribe to this information