You might need to reset your tape drive.
Use the procedure in this topic to perform this task.
Use this information to reset your tape drive, without affecting
server operation. Allow up to 2 minutes for the entire tape drive process
to complete.
Attention: Resetting a tape drive before the current
backup operation has completed can cause loss of customer data.
To
reset the tape drive, follow these steps:
Press and hold the eject button for 20 seconds, and then release
the button. The LEDs on the drive will be flashing while the reset
function is in process.
When the LEDs stop flashing, wait approximately one minute for
the drive to complete the reset operation. The drive will then
be ready to use.
Subscribe to this information