HD85613: NO CONTROL DURING RENAME OF NUMBER FIELDS FOR FEATURE

APAR status

• Closed as unreproducible in next release.

Error description

• No control during rename of number fields for
  feature
  SCENARIO:
  1)Connect PORTAL
  2)Connect to VPM
  3)Create the part PART-1
  4)Create one FEATSAMP with CUR. Val = 1
  5)Click on properties and modify CUR. Val = z
  .
  RESULT: => No error during the save and save of
  epsilon value is possible.
  NOTE: In VPM it is OK - there is an error and the save is
  not done - Expected behaviour in 3dcom too
  .
  

Local fix

Problem summary

• No control during rename of number fields for feature
  No control during rename of number fields for
  feature
  SCENARIO:
  1)Connect PORTAL
  2)Connect to VPM
  3)Create the part PART-1
  4)Create one FEATSAMP with CUR. Val = 1
  5)Click on properties and modify CUR. Val = z
  .
  RESULT: => No error during the save and save of
  epsilon value is possible.
  NOTE: In VPM it is OK.
  .
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON ENOVIA VPM
  1.6.
  THIS PROBLEM IS NOT REPRODUCIBLE ON ENOVIA
  VPM 1.6 PTF15 LEVEL.
  NOTE: THIS PROBLEM IS ALSO NOT
  REPRODUCIBLE FROM VPM1.6PTF13 LEVEL.
  Incident Diagnosis:
  No control during rename of number fields for
  feature
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  ENOVIA VPM AIX

• Fixed component ID

  569101900

Applicable component levels

• R160 PSN UH96315

     UP09/08/03 I 1000