After your SNTP server runs, you must configure
other systems in the network to use System A as the SNTP server.
In this scenario, you need to configure the SNTP client on System B.
You might need to refer to other system documentation to configure
clients in your network.
To configure the SNTP client
on System B, follow these steps:
- From System i® Navigator,
expand .
- Right-click SNTP and select Properties.
- Click the following tabs to set the parameters:
- On the General tab, click Client to
start the SNTP client when TCP/IP starts.
- On the Client tab, specify the following
values:
- Time servers:
systemA.yourco.com
- Poll interval: 60 minutes
- Minimum adjustment: 20 milliseconds
- Maximum adjustment: 20 minutes
- Adjustment threshold: Maximum adjustment
- Activity logging: Only when adjusting the system clock