Work with CICS TCS (WRKCICSTCS)

Use the Work with CICS Terminal Control System Table (WRKCICSTCS) command to list entries in the TCS table. You can change, remove, copy or display entries, or add new ones to the list.

Parameters

Library (LIB)

Enter the name of the IBM i library which contains the group.

Possible values are:

• *LIBL: The library list is used to locate the first IBM i library that contains the group.
• *CURLIB: The current library contains the group. If no library is specified as the current library, the QGPL library is used.
• library-name: Specify the name of the IBM i library that contains the group.

Group (GROUP)

Enter the name of the group from which the TCS table entries are to be listed.

Possible values are:

• *FIRST: No group is specified. The first group found is used.
• group-name: The group name may have a maximum length of 10 characters. The first character must be alphabetic, or one of the special characters, $, @, or #. The remaining characters can be alphanumeric or one of the special characters, $, @, or #.

Remote CICS system (SYSID)

Enter the name of the TCS table entry to be listed. This is the system identifier used to identify the remote CICS system.

Possible values are:

• *ALL: List all TCS entries.
• *FIRST: List the first TCS entry.
• system-identifier: The system identifier may have a maximum length of 4 characters. The first character must be alphabetic, or one of the special characters, $, @, or #. The remaining characters can be alphanumeric or one of the special characters, $, @, or #.
• generic*-sysid: Specify the generic name of the system identifier. A generic name is a character string of one or more characters followed by an asterisk (*); for example, ABC*. If a generic name is specified, then all TCS Table entries with the system identifier that begins with the generic name are displayed. If an asterisk is not included with the generic (prefix) name, the system assumes it to be the complete system identifier.

Examples

Error messages