Resume Controller Recovery (RSMCTLRCY)
Where allowed to run: All environments (*ALL) Threadsafe: No |
Parameters Examples Error messages |
The Resume Controller Recovery (RSMCTLRCY) command resumes error recovery procedures for a specific controller. Error recovery procedures can be ended by using the End Controller Recovery (ENDCTLRCY) command or by responding to a failure-related inquiry message with a cancel option.
The Resume Controller Recovery (RSMCTLRCY) command allows you to resume automatic error recovery procedures after they have been stopped, and to reactivate a controller (and jobs using that controller) after it has been canceled. (if the C response was entered to the inquiry message associated with a controller failure). When the controller is canceled with the C response, all jobs are ended; once the controller is repaired and the RSMCTLRCY command is entered, jobs are allowed to start using the controller again.
Restriction: To use this command, the user must have object operational authority for the controller.
Top |
Controller (CTL)
Specifies the controller for which error recovery procedures are to resume. Valid types of controllers are:
- CTL Value
- Controller
- 5251
- Display station
- *PU2
- Physical unit (type 2); SDLCs for basic BSC and RJE
- *BSC
- BSC device (basic BSC and RJE)
- *BSCT
- BSC device (Multipoint tributary and 3270 Device Emulation)
- *APPC
- Advanced program-to-program communications
- *WSC
- Local work station
- *WSCE
- Local work station (extended)
This is a required parameter.
Top |
Examples
RSMCTLRCY CTL(TROLL3)
This command resumes error recovery procedures for the controller TROLL3.
Top |
Error messages
*ESCAPE Messages
- CPF2703
- Controller description &1 not found.
- CPF5924
- Controller &1 does not allow automatic error recovery.
- CPF5928
- Controller &1 not varied on.
- CPF5929
- Controller &1 assigned to another job.
- CPF5930
- Recovery not resumed for controller &1.
- CPF5931
- Recovery not resumed for controller &1.
- CPF5935
- Error occurred during command processing.
- CPF5936
- Not authorized to controller &1.
Top |