Display Sphere of Control Sts (DSPSOCSTS)
Where allowed to run: All environments (*ALL) Threadsafe: No |
Parameters Examples Error messages |
The Display Sphere of Control Status (DSPSOCSTS) command shows the status of the sphere of control including primary, default, back up, and requested nodes.
More information about displaying the sphere of control status and using the DSPSOCSTS command is in the Alerts Support book, SC41-5413.
Top |
Parameters
Keyword | Description | Choices | Notes |
---|---|---|---|
OUTPUT | Output | Optional, Positional 1 | |
DETAIL | Detail | *BASIC, *FULL | Optional |
Top |
Output (OUTPUT)
Specifies whether the output from the command is displayed at the requesting work station or printed with the job's spooled output.
- *
- Output requested by an interactive job is shown on the display. Output requested by a batch job is printed with the job's spooled output.
- The output is printed with the job's spooled output.
Top |
Detail (DETAIL)
Specifies whether the output from the command is printed as a list of nodes or as a detailed description of each node in the sphere of control. This parameter is valid only when OUTPUT(*PRINT) is specified.
- *BASIC
- A list of nodes in the sphere of control is printed.
- *FULL
- A list of nodes in the sphere of control with detailed information for each node is printed.
Top |
Examples
DSPSOCSTS
This command shows the Sphere of Control Status display at the requesting work station.
Top |
Error messages
None
Top |