Displaying Active Watches

To display a system-wide list of active watches and show which job set them, type:

DSPDBGWCH

on a debug command line. This command brings up the Display Debug Watches display shown below.

Figure 116. Example of a Display Debug Watch Display

                              Display Debug Watches
                                                              System:  
  ------------Job---------------        NUM     LENGTH     ADDRESS
  MYJOBNAME1  MYUSERPRF1  123456          1          5     080090506F027004
  JOB4567890  PRF4567890  222222          1          8     09849403845A2C32
  JOB4567890  PRF4567890  222222          2          2     098494038456AA00
  JOB         PROFILE     333333         14          4     040689578309AF09
  SOMEJOB     SOMEPROFIL  444444          3          4     005498348048242A
Bottom
 Press Enter to continue
 F3=Exit  F5=Refresh   F12=Cancel

Note:

This display does not show watch conditions set by the system.

[ Top of Page | Previous Page | Next Page | Contents | Index ]