Resuming the Restore Storage (RSTSTG) operation
You can use this procedure to resume the restore storage operation that ended before the entire restore operation of the disk unit data was completed.
To start the RSTSTG operation again, follow these steps:
If the restore storage operation continues to fail on the same tape with a tape media failure, you have the following three options:
- Use a previous copy of your save storage tapes to completely restore storage.
- Resume the restore storage operation by using the tape following the tape
with the media error. If the tape that has the media error is the last tape
to restore in the set, option 3 (Force end of an interrupted restore storage)
on the Restore Storage menu should be selected.Attention: Some disk unit data is not restored. There might also be many objects that are damaged on the system when the restore operation completes. An initial program load of the operating system might not be successful. You should restore the operating system again.
- Initialize your system and then begin a restore of your system from the tapes that were created using Save System (SAVSYS) and Save Library (SAVLIB) commands or options from the Save menu.