| 1 | View ID | Input | Binary(4) |
| 2 | Line number | Input | Binary(4) |
| 3 | Column number | Input | Binary(4) |
| 4 | Line in statement view | Output | Binary(4) |
| 5 | Error code | I/O | Char(*) |
The calling program uses the Remove Breakpoint (QteRemoveBreakpoint) API to remove a breakpoint from a location in a registered view. The API will complete normally whether or not there was actually a breakpoint previously added to that location.
None.
The identifier of a previously registered view obtained by using the Register Debug View API.
The line in the view ID where the breakpoint is to be removed.
The column in the line where the breakpoint is to be removed.
Note: At this time, column numbers are ignored. Column one must be specified.
The API returns the line number in the statement view where the breakpoint was removed.
The structure in which to return error information. For the format of the structure, see Error code parameter.
| Message ID | Error Message Text |
|---|---|
| CPF1938 E | Command is not allowed while serviced job is not active. |
| CPF1939 E | Time-out occurred waiting for a reply from the serviced job. |
| CPF1941 E | Serviced job has completed. Debug commands are not allowed. |
| CPF3CF1 E | Error code parameter not valid. |
| CPF9541 E | Not in debug mode. |
| CPF9542 E | View not found. |
| CPF9549 E | Error addressing API parameter. |
| CPF9567 E | Column number not valid. |
| CPF9568 E | Line number not valid. |
[ Back to top | Debugger APIs | APIs by category ]