replacepv Command

Edit online

Purpose

Replaces a physical volume in a volume group with another physical volume.

Syntax

replacepv [  -f ] {SourcePhysicalVolume | SourcePhysicalVolumeID } DestinationPhysicalVolume

replacepv [  -R ] dir_name  [ DestinationPhysicalVolume ]

Description

The replacepv command replaces allocated physical partitions and the data they contain from the SourcePhysicalVolume to DestinationPhysicalVolume. The specified source physical volume cannot be the same as DestinationPhysicalVolume.
Note:
  1. The DestinationPhysicalVolume must not belong to a volume group.
  2. The DestinationPhysicalVolume size must be at least the size of the SourcePhysicalVolume.
  3. The replacepv command cannot replace a SourcePhysicalVolume with stale logical volume unless this logical volume has a non-stale mirror.
  4. You cannot use the replacepv command on a snapshot volume group or a volume group that has a snapshot volume group.
  5. Running this command on a physical volume that has an active firmware assisted dump logical volume temporarily changes the dump device to /dev/sysdumpnull. After the migration of logical volume is successful, this command calls the sysdumpdev -P command to set the firmware assisted dump logical volume to the original logical volume.
  6. The VG corresponding to the SourcePhysicalVolume is examined to determine if a PV type restriction exists. If a restriction exists, the DestinationPhysicalVolume is examined to ensure that it meets the restriction. If it does not meet the PV type restriction, the command will fail.

The allocation of the new physical partitions follows the policies defined for the logical volumes that contain the physical partitions being replaced.

Flags

Item Description
-f Forces to replace a SourcePhysicalVolume with the specified DestinationPhysicalVolume unless the DestinationPhysicalVolume is part of another volume group in the Device Configuration Database or a volume group that is active.
-R dir_name Recovers replacepv if it is interrupted by <ctrl-c>, a system crash, or a loss of quorum. When using the -R flag, you must specify the directory name given during the initial run of replacepv. This flag also allows you to change the DestinationPhysicalVolume.

Security

Access Control: You must have root authority to run this command.

Examples

  1. To replace physical partitions from hdisk1 to hdisk6, enter: 
    replacepv hdisk1 hdisk6

Files

Item Description
/usr/sbin Directory where the replacepv command resides.
/tmp Directory where the temporary files are stored while the command is running.