You must configure each database used in the IBM®
Connections deployment for Unicode. Configuration for Unicode must be set before Connections
installation because it cannot be set after installation.
Procedure
You must perform the following steps on each DB2®
instance in the deployment:
- Stop any WebSphere® server connected to the DB2 database you are configuring.
- Log in to the DB2 server as the DB2 instance owner.
- Open the DB2 command window.
- Run the following commands:
db2set DB2CODEPAGE=1208
db2stop force
db2start
- Run the following commands to check the new configuration:
db2set
This should return DB2CODEPAGE=1208. If not, it is not configured
correctly and you should try Step 4 again.