Installing GSKit

You can install the GSKit package through the swinstall command.

To install GSKit, run the following command at a command prompt:

• For 64-bit GSKit:

  swinstall  -s <extracted_path>/tdsV6.3/gskit/gskcrypt64  gskcrypt64 
  swinstall  -s <extracted_path>/tdsV6.3/gskit/gskssl64   gskssl64 

  where. -s specifies the full_path of the software source.
• For 32-bit GSKit:

  swinstall  -s <extracted_path>/tdsV6.3/gskit/gskcrypt32  gskcrypt32 
  swinstall  -s <extracted_path>/tdsV6.3/gskit/gskssl32   gskssl32 

  where. -s specifies the full_path of the software source.

See Appendix Q. Setting up GSKit to support CMS key databases for more information about setting up GSKit after installation.

[ Top of Page | Previous Page | Next Page ]