Installing GSKit

Use the following information to install GSKit 8.0 through the command line.

The package names for GSKit 8.0 on the Linux platforms are as follows:

System x® Linux:

gskcrypt32-8.0.13.1.linux.x86.rpm

gskssl32-8.0.13.1.linux.x86.rpm

System z® Linux (32-bit):

gskcrypt31-8.0.13.1.linux.s390.rpm

gskssl31-8.0.13.1.linux.s390.rpm

System z Linux (64-bit):

gskcrypt64-8.0.13.1.linux.s390x.rpm

gskssl64-8.0.13.1.linux.s390x.rpm

System i® and System p® Linux (32-bit):

gskcrypt32-8.0.13.1.linux.ppc.rpm

gskssl32-8.0.13.1.linux.ppc.rpm

System i and System p Linux (64-bit):

gskcrypt64-8.0.13.1.linux.ppc.rpm

gskssl64-8.0.13.1.linux.ppc.rpm

Linux IA64 (Itanium) and AMD64/EM64T Linux (32-bit):

gskcrypt32-8.0.13.1.linux.x86.rpm

gskssl32-8.0.13.1.linux.x86.rpm

Linux IA64 (Itanium) and AMD64/EM64T Linux (64-bit):

gskcrypt64-8.0.13.1.linux.x86_64.rpm

gskssl64-8.0.13.1.linux.x86_64.rpm

To install GSKit using rpm, log in as root, go to the directory where the GSKit file is, and type the following at a command prompt: (This example uses the System x Linux package name.)

rpm -ihv gskcrypt32-8.0.13.1.linux.x86.rpm
rpm -ihv gskssl32-8.0.13.1.linux.x86.rpm

See Appendix Q. Setting up GSKit to support CMS key databases for more information about setting up GSKit after installation.

[ Top of Page | Previous Page | Next Page ]