You can run several
locations on the same computer by configuring multiple host names
for a location. This configuration affects all tests running at that
location; all tests will run with the configured port.
Procedure
To configure multiple host names for a location:
- Open the hosts file,
which maps IP addresses to hosts, with an ASCII editor. On Windows, the hosts file
is in C:\\Windows\system32\drivers\etc\hosts.
On Linux, the hosts file is
in \etc\hosts
- At the end of the hosts
file, add your IP mappings. Use one IP address, but map it to two
(or more) logical host names. For example, you could
add map the IP address 123.4.5.6. to two logical hosts, as show in
the bottom two lines:
- Create two deployment
locations that have names identical to the names you added in the
hosts file:
- Open the schedule that contains the user group that
you want to run on multiple hosts.
- Open the user group, and click the Location tab.
- Click , and enter the location data. Make
sure the locations have different directories (in this example, they
are tempa and tempb).
- Click .