After you have configured
aliases at on remote computers, you set the schedule so that the virtual
users can use the configured IP aliases.
Before you begin
Before you can enable virtual users
to use IP aliases, you must:
- Configure the aliases at the remote location.
- Add the remote location to the user group.
Procedure
To set the schedule so that the virtual users will use
the IP aliases during a run:
- In the Test Navigator, browse to the schedule and double-click
it. The schedule opens.
- Click the user group whose virtual users will use aliasing.
- Click Run this group on the following locations. The list of locations shows whether IP aliasing
is enabled at that location.
- To change whether IP aliasing is enabled or disabled, click
a row in the table, and then click Edit.
- On the IP aliasing page, click Enable IP Aliasing.
Option |
Select when |
Use IP addresses from all network interfaces |
You have one network interface, or you have multiple interfaces
and want to use them all. |
Only use IP addresses from the following network interfaces |
You want to use some, but not all, network interfaces. Select
the check box next to the interfaces that you want to use. Click Add to add a new network interface. Typically, you enter
an interface name in the form eth0 (Windows and Linux) or
en0 (AIX®). |