Collector Node sample

The Collector Node sample demonstrates how you can use the Collector node to combine a number of messages from different sources, and produce a single output.

The sample shows two uses of the Collector node:

• Combining messages that share a common correlation field
• Grouping messages that arrive in a specified time interval

Click the following links to find out more about the sample and how to get the prebuilt sample to run by using the wizards.

Import and deploy: 5 minutes

Read about the sample

Setup instructions

You can set up the sample in one of the following ways:

• Import and deploy the sample

  This option imports the sample files into your workspace and deploys the sample to the integration node. This option also sets up additional resources for the sample, for example, WebSphere MQ queues.

• Import the sample

  This option imports the sample files into your workspace. Additional manual steps might be required to configure the sample for testing.

You can import or import and deploy a sample only when you use the information center that is integrated with the IBM Integration Toolkit.

Run the sample

When you have finished with the sample, you can remove it in one of the following ways:

• Remove the sample from the integration node, but leave its resources in the workspace
• Remove the sample from the integration node and the workspace