Use the following steps to install the IBM Integration Explorer using the console mode on Linux. If you encounter any problems
during the installation process, you can view the install log IBExplorer_install.log.
- Type the following command on a command line to run a console
install:
<cd_rom>/IBExplorer/install.bin -i console
- Select the language that you want to use for the installation
process by typing the number next to the language and press Enter. The installer uses the term "locale" rather than "language".
Alternatively, press Enter to accept the default
language.
- Read the software license agreement and type 1 to accept
the terms of the license. Press Enter.
- Type the name of the product installation directory for
the IBM Integration Explorer and press Enter.
Alternatively, press Enter to accept the default
location. The default installation directory for the IBM Integration Explorer on Linux systems is /opt/IBM/IBExplorer. If
the product installation directory already exists because you have
previously installed the IBM Integration Explorer,
you can either refresh the existing installation or select a new product
directory.
- Confirm that the install location is correct, and press Enter to
continue.
- Read the Pre-Installation Summary information and press Enter to
install the IBM Integration Explorer. Wait while
the files are installed.
- On the Installation Complete panel,
press Enter to exit the console installer.
You can now use the IBM Integration Explorer.
To use the IBM Integration Explorer you must start
the WebSphere® MQ Explorer. To start the WebSphere MQ Explorer, open a command shell
in which the mqsiprofile command
has not been run and enter the strmqcfg command,
or run /usr/bin/strmqcfg.