From the Send Message dialog, you can select a previously saved
recorded message and send it to the message flow.
Before you begin
You must have the following components:
- A message flow that is in recording mode
- One or more recorded messages
About this task
Recorded messages are created by sending input messages to a message flow by using the
Flow Exerciser. A recorded message contains the logical message
tree assembly that is the result of an input node processing an input message. You cannot
modify the recorded message or create one from scratch. For more information, see Messages that you can use.
Procedure
-
Click the Send message to the flow icon () in the Flow Exerciser toolbar.
The Send Message dialog opens. The recorded messages that
you previously saved are listed under Recorded Messages in the
navigator.
-
Select a recorded message to see the content.
You can change the name of the recorded message if you want, by typing a new name and
clicking Apply. However, you cannot duplicate the message or edit
the content of the message.
-
By default, the recorded message is sent to the input node where it was saved. If there
are other input nodes of the same type in the message flow, you can select one of these
other input nodes instead.
Note: If you select an input node other than the input node where the message was saved,
you might get an error in your flow when you send the message. For example, the selected
input node might send messages in a different format.
-
Click Send.
The message is sent to the flow, and the connections through which the message
passed are highlighted.