Message Sets: Configuring Custom Wire Format (CWF) properties: Message sets

Configure the Custom Wire Format (CWF) properties of a message set using the Message Set editor.

Before you begin

You must have completed the following tasks:

• Message Sets: Creating a message set
• Message Sets: Opening an existing message set
• Message Sets: Adding a Custom Wire Format (CWF)

About this task

To configure the CWF properties of a message set:

1. Switch to the Integration Development perspective.
2. In the Message Set editor, the Custom Wire Formats node of the Properties Hierarchy shows the name of each of the CWF physical formats that have been added to the message set. If the physical format names are not in view, expand Custom Wire Formats by clicking +.
3. Click the chosen CWF physical format so that the properties of this format appear in the Details view of the Message Set editor.
4. Configure the CWF properties shown in the Details view according to your requirements.
5. Save your changes either by clicking File> Save or by pressing Ctrl+S. Alternatively click File> Save All or press Ctrl+Shift+S.

Results