CNZHF0005I One or more consoles are configured to receive messages intended only for programmers.

Explanation
 One or more consoles are configured to receive
messages with routing code 11.  Messages issued with routing code
11 are intended to be sent to the programmer, not the operator console.
Note: For active MCS, SMCS and HMCS consoles,
only the consoles active on this system are checked.  For inactive
MCS, SMCS and HMCS consoles, all  consoles are
checked.  For system consoles, the check is applicable only if the
console is receiving messages with routing code 11 when  running in
Problem Determination (PD) mode.

System action
 The system continues processing.

Operator response
 Report this problem to the system programmer.

System programmer response
 To view the attributes of all consoles,
issue the following commands:      DISPLAY CONSOLES,L,FULL                                                      
DISPLAY EMCS,FULL,KEY=SYSCONS
Update the ROUTCODE parameter
on the CONSOLE statement of the CONSOLxx parmlib member before the
next IPL.   To have the updates in effect immediately, you may remove
routing  code 11 from the routing codes received by a console using
the following command:     VARY CN(console_name),DROUT=11

 Note: The VARY CN system command can only
be used to set the attributes of an active console. When the
system console (HMC) is placed in PD mode, the CNZ_Console_Routcode_11
check will examine the saved route code setting that the system console
uses.  If the system console is not in PD mode, the DISPLAY EMCS,FULL,KEY=SYSCONS
command shows a route code of NONE.  To display the saved route code
setting, first place the system console in PD mode by issuing a V
CN(*),ACTIVATE command from the system console.  Then issue the DISPLAY
command and if needed, the VARY command shown previously to remove
routing code 11.  After the appropriate changes have been made, you
can issue the V CN(*),DEACTIVATE command to remove the system console
from PD mode.

Problem determination
 N/A

Module
 CNZH1CKF

Source
 Consoles (SC1CK)

Reference Documentation
        z/OS MVS Initialization and Tuning Reference
z/OS MVS System Commands
z/OS MVS Planning: Operations

Automation
 N/A

Routing Code
 -

Descriptor Code
 12