Syntax
|
Single Subparameter: You can omit the
parentheses if you code only the subsystem-name. Number of Subparameters : If needed, you can code up to 254 subsystem-subparameters on a JES2 system (the length of all parm-statements cannot exceed about 8 KB on a JES2 system), or up to 1020 bytes of data on a JES3 system. Multiple Subparameters: When the parameter contains more than the subsystem-name, separate the subparameters by commas and enclose the subparameter list in parentheses. For example, SUBSYS=(XYZ,1724,DT25). Positional Subparameters: If you omit a subparameter that the subsystem considers positional, code a comma in its place. Special Characters: When a subparameter contains special characters, enclose the subparameter in apostrophes. For example, SUBSYS=(XYZ,1724,'KEY=Y'). Code each apostrophe that is part of a subparameter as two consecutive apostrophes. For example, code O'Day as SUBSYS=(XYX,1724,'NAME=O''DAY'). If you code a symbolic parameter on the SUBSYS parameter, you can code the symbolic parameter in apostrophes. Continuation
onto Another Statement: Enclose the subparameter list in only
one set of parentheses. End each statement with a comma after a complete
subparameter. For example:
Note: The SUBSYS
parameter can have a null value only when coded on a DD which either:
|