Explanation
This message is the first in a group of messages
that VTAM® issues in response
to one or both of the following:
- A VARY ACT command that specified LOADFROM, SAVEMOD, or DUMPLOAD
for NCP ncpname
- A PCCU definition statement that specified LOADFROM, SAVEMOD,
or DUMPLOAD for NCP ncpname.
A complete description of the message group follows.
IST499I DISK FUNCTIONS FOR ncpname NOT PERFORMED
IST523I REASON = reason
reason in
message IST523I is one of the following:
- LOAD NOT NECESSARY
- The operator entered a VARY ACT command specifying LOAD=U. Because
no load occurs, the functions are not set in NCP ncpname.
- CCU NOT CORRECT LEVEL
- NCP NOT CORRECT LEVEL
- SSP NOT CORRECT LEVEL
- The controller (CCU), NCP, or SSP does not support the function
requested. An NCP release prior to NCP V5R2 cannot be loaded with
the LOADFROM, SAVEMOD, or DUMPLOAD operands. These operands are valid
only for NCP V5R2 or a later release.
System action
Activation continues. The LOADFROM, SAVEMOD,
and DUMPLOAD operands are ignored.
Operator response
System programmer response
Ensure that the NCP, SSP, and CCU
are at the correct level. To use the LOADFROM, SAVEMOD, and DUMPLOAD
operands on the VARY ACT command, the NCP must be NCP V5R2 or a later
release, and the SSP must be SSP V3R4 or a later release.
Routing code
Descriptor code