To run PKI Services in
parallel, the UNIX programmer
must specify SharedPLEX=T in the pkiserv.conf configuration
file. (See the SharedPLEX=T row in Table 1.) The MVS™ programmer enables the sysplex to access
the VSAM data sets.
Procedure
Perform the following steps to
enable your existing
PKI Services data sets
for VSAM record-level sharing (RLS).
- Copy the sample reallocation JCL in SYS1.SAMPLIB(IKYRVSAM) to
your JCL data set.
Attention: Do
not run IKYCVSAM by mistake because this JCL will destroy your existing
VSAM data sets.
_______________________________________________________________
- Update your data set, following the instructions in the prolog
of the sample JCL:
- Change the JOB card.
- Change the STORCLAS statements.
Note: Before submitting this job,
check your access control service (ACS) routines for naming convention
definitions that will be used to create the VSAM RLS data sets.
- Rename the source data sets to the names of your existing object
store and ICL data sets.
- Change the destination data set names.
- Update the primary and secondary extent allocations based on your
anticipated future needs. (See Planning VSAM storage requirements for
guidelines on determining the space you will need.) These are the
default allocations for each type of data set:
- Base cluster
- CYL(3,1)
- Alternate indexes
- TRK(5,1)
Guideline: Do not change any numeric values,
other than the primary and secondary space allocation values for the
base cluster and alternate index data sets.
_______________________________________________________________
- Submit the job when your changes are complete.
_______________________________________________________________