Use the IPCS RSMDATA subcommand to obtain information about storage usage and any unusual condition that have occurred prior to requesting the stand-alone dump. In the RSMDATA output, if the percent usage field is 100%, there are no frames left. Also, the percent of available total fixed frames should not be a high number. If it is, there can be a program using too many resources to complete. For example, in Figure 1, the percent of available total fixed frames is at 25%.
R S M S U M M A R Y R E P O R T
Tot real Below Prf real Dbl real Expanded
-------- ----- -------- -------- -------------
In configuration . . . . 33,792 4,096 33,742 - 49,152
Available for allocation 32,672 4,089 33,742 120 49,152
Allocated . . . . . . . 32,398 3,964 33,483 113 48,594
Percent usage . . . . . 99 96 99 94 98
Common fixed frames . . 3,087 317 3,087 - -
Percent of available . 9 7 9 - -
Total fixed frames . . . 8,338 907 - - -
Percent of available . 25 22 - - -
You can also check the ASM control blocks to determine the statistics applicable to I/O requests. The I/O requests received and completed should be the same. In Figure 2, note that the 509577 I/O requests received have all been completed.
ASMVT AT 00FD8030
509577 I/O REQUESTS RECEIVED, 509577 I/O REQUESTS COMPLETED BY ASM
240487 NON-SWAP WRITE I/O REQUESTS RECEIVED, 240487 NON-SWAP WRITE I/O
REQUESTS COMPLETE
PART AT 01CB5310
PAGE DATA SET 0 IS ON UNIT 15B
PAGE DATA SET 1 IS ON UNIT 15B
PAGE DATA SET 3 IS ON UNIT 14A
PAGE DATA SET 4 IS ON UNIT 150
PAGE DATA SET 5 IS ON UNIT 15B