STOP MANAGER

Use the STOP MANAGER command to stop processing of the Provisioning Manager. After the Provisioning Manager is requested to stop, it does not accept any other commands. The state of resources does not change. Any additionally provisioned capacity remains active.

Syntax

Read syntax diagramSkip visual syntax diagram                      .-MODE= NORMAL-.
>>-+-STOP--MANAGER-+--+--------------+-------------------------><
   '-P--M----------'  '-MODE= FORCE--'

Parameters

The command has the following parameter:

MODE
Mode in which you want to end the Provisioning Manager. There are two supported stop modes:
NORMAL
The default stop mode is to terminate all processing and to unregister the Provisioning Manager from ARM if applicable
FORCE
To stop processing immediately. If the Provisioning Manager is registered with ARM, the process restart.
The mode values are not case-sensitive.

Example

To stop the Provisioning Manager, issue the following command:

MODIFY CPOSERV,APPL=STOP MANAGER

or:

F CPOSERV,APPL=P M

The response on the console might be:

CPO1007I Stop command for the Provisioning Manager accepted