IXC269D

Explanation
This system detected an inconsistency in the couple
data sets specified in COUPLExx.  This system has resolved the inconsistency
and has found a consistent primary and alternate couple data set. However, it does not appear that any active systems
are using those data sets. Message IXC275I has been issued to identify
the couple data sets specified by COUPLExx, as well as the resolved
couple data sets that this system has determined to be consistent.
In
the message text: xx
The suffix identifying the COUPLE parmlib member.

System action
System initialization processing stops until the
operator replies to message IXC269D.

Operator response
Choose one of the following replies: U
To continue initialization with the resolved couple
data sets that XCF has determined to be the most recently used configuration.
C
To continue initialization processing with the couple data sets
that were specified in COUPLExx.
R
To request that XCF be reinitialized. XCF will stop using the
current couple data sets and issue message IXC207A to prompt the operator
for a new COUPLExx parmlib member.

 If an incorrect reply is entered, the system issues
message IXC208I to notify the operator of the error. The system then
reissues message IXC269D.
Notify the system programmer.

System programmer response
This message indicates
that the COUPLExx parmlib member specifies a sysplex couple data set
configuration that is not the configuration currently or most recently
used by the sysplex. This could be caused by the removal of a primary
or an alternate or by the addition of a new alternate couple data
set. Updating the COUPLExx parmlib member to describe the in-use or
last-used couple data set configuration should eliminate this message.

Source
Cross System Coupling Facility (SCXCF)

Module
IXCL1DSI

Routing code
1,2

Descriptor code
2