Explanation
XCF cannot initialize this system into the sysplex
because the current COUPLExx parmlib member is unusable. A previous
message states why the current COUPLExx parmlib member cannot be used.
In
the message text:
- xx
- The suffix identifying the COUPLE parmlib member.
System action
System initialization stops until the operator
specifies a new COUPLExx parmlib member.
Operator response
Do one of the following:
- Reply COUPLExx, where xx is
either:
- The same suffix to try the same COUPLExx parmlib member again.
- A different suffix to specify an alternate COUPLExx parmlib member,
if there is one available. Then notify the system programmer.
- If there is no alternate COUPLExx parmlib member, notify the system
programmer, who will correct the COUPLExx parmlib member. Provide
any preceding informational messages.
After the system programmer
corrects the COUPLExx parmlib member, respecify it.
If it is
necessary to reIPL to correct the COUPLExx parmlib member, specify
COUPLE=00 to IPL the system in XCF-local mode. Make sure the data
set is protected with adequate serialization.
- Have another system that shares access to the SYS1.PARMLIB data
set fix any errors in the COUPLExx parmlib member in error. Then
reply COUPLE=xx to specify the same COUPLExx parmlib
member.
System programmer response
Do one of the following:
- If there is an alternate COUPLExx parmlib member available, have
the operator specify the alternate. Correct the current COUPLExx parmlib
member.
- If there is no alternate COUPLExx parmlib member available, correct
the COUPLExx parmlib member before system initialization can continue.
Look for a preceding message explaining the problem. When the parmlib
member is correct, ask the operator to respecify it.
Source
Cross System Coupling Facility (SCXCF)
Module
Routing code
Descriptor code