Explanation
The designated system has been removed from the
sysplex. MVS™ is unable to initiate
restarts of the elements from the designated system on another system
for the reason indicated by text.
In the
message text:
- sysname
- The name of the system that has been removed from the sysplex.
- ARM RESTARTS ARE NOT ENABLED.
- Restarts of registered elements either have never been enabled
(through a SETXCF START command) or have been disabled (through a
SETXCF STOP command).
- THRESHOLD FOR SYSTEM TERMINATIONS REACHED.
- The number of systems that have left the sysplex within the system
designated interval has reached the threshold where MVS no longer restarts elements from a terminated
system.
- SYSTEM sysname LOST ACCESS TO THE ARM COUPLE
DATA SET DURING RESTART PROCESSING.
- The system has lost access to the ARM couple data set while initiating
restarts of the elements from the designated system.
- sysname
- The name of the system that incurred the error that prevented
the elements from being restarted.
- INTERNAL ERROR DURING ARM RESTART PROCESSING ON SYSTEM currsys.
DIAG106: diag106
- An internal processing error occurred during cross-system restart
processing. MVS will not restart
this element.
- currsys
- The name of the current system.
- diag106
- An internal diagnostic code that the IBM® Support
Center might request.
System action
MVS deregisters
elements that had been running on the terminated system.
Operator response
If restarts are not enabled, then determine
if you should enable them (through a SETXCF START command). You may
also want to determine if you should manually restart the elements
from the terminated system on another system in the sysplex.
System programmer response
If the threshold for system terminations
has been reached then determine the reason for the system terminations.
Source
Cross System Coupling Facility (SCXCF)
Module
Routing code
Descriptor code