Explanation
XCF found incorrect syntax or options specified
on the VARY XCF command. The message text shows the syntax error.
In
the message text:
- reason-code
- The reason code.
- SYSTEM NAME SPECIFIED IS NOT VALID
- The system name specified is incorrect.
- THE ONLY ALLOWABLE OPTIONS ARE OFFLINE, RETAIN®, REIPL, SADMP AND FORCE
- The option specified is incorrect.
- THE ONLY ALLOWABLE OPTIONS FOR RETAIN ARE
YES OR NO
- The option specified for RETAIN is
incorrect.
- OFFLINE MUST BE SPECIFIED
- OFFLINE was not specified on the command.
- INSUFFICIENT COMMAND AUTHORITY
- Authority is insufficient for the command.
- REQUEST WAS CANCELLED BY THE OPERATOR
- The VARY XCF command was cancelled by the operator.
- VARY REQUEST IS NOT VALID
- The VARY XCF command request is incorrect.
- THE SYSTEM IS CURRENTLY IN XCF-LOCAL MODE
- The system is running in XCF-local mode.
- FORCE OPTION IS NOT ACCEPTABLE AT THIS TIME
- The operator must remove a system with the VARY XCF command before
entering a VARY XCF,FORCE command.
- THE CURRENT SYSTEM IS IN PARTITIONING
- The operator entered the VARY XCF command on this system to remove
another system from the sysplex. However, the system on which the
command was entered is already being removed from the sysplex, and
so cannot remove another system.
- REIPL NOT ALLOWED WHEN SPECIFYING RETAIN=NO
- The definitions of the devices for signaling paths to the removed
system must be retained if an automatic re-IPL of the removed system
is requested. Do not specify RETAIN=NO if a re-IPL of the removed
system is required.
- REIPL OR SADMP NOT ALLOWED WHEN SPECIFYING FORCE
- You cannot request an automatic re-IPL or automatic stand-alone
dump of a system on a VARY command that specifies the FORCE keyword.
Issue the VARY command without the SADMP or REIPL keywords.
- DUPLICATE KEYWORD SPECIFIED
- The keyword specified is a duplicate.
- FORCE OPTION USED WITHOUT SYSTEM RESET
- The FORCE option was specified, but XCF system status detection
determined that the target system has not been through a system reset.
Target system must go through a system reset before the FORCE option
can be used.
- AN UNEXPECTED ERROR OCCURRED, REASON=reason-code
- An unexpected error occurred during the processing of the VARY
XCF command. A reason code is returned.
System action
Operator response
If necessary, reenter the command with the
correct syntax.
System programmer response
If AN UNEXPECTED ERROR OCCURRED.
REASON=reason-code appears in the message text,
or if the problem persists, search problem reporting data bases for
a fix for the problem. If no fix exists, contact the IBM® Support Center.
Source
Cross System Coupling Facility (SCXCF)
Module
Routing code
Descriptor code