Explanation
This system encountered an error while attempting
to access the couple datsets specified in COUPLExx. The system was
able to determine a candidate couple data set configuration, but could
not determine whether there are other active systems using a different
couple data set configuration. Message IXC275I has been issued to
identify the candidate configuration.
System action
System initialization processing stops until the
operator replies to message IXC222D.
Operator response
Choose one of the following replies:
- U
- To continue initialization processing using the candidate couple
data set configuration described by IXC275I.
Note: Choose this option
only if there are no other active systems in the sysplex. When other
active systems exist and are using another couple data set configuration,
responding 'U' might cause those systems to fail. The IPLing system
will reinitialize function couple data sets, such as CFRM, ARM, SFM,
etc. that are described in COUPLExx because it will conclude that
no other system is using them. The reinitialization will prevent the
active systems from using them, causing WAIT 0A2 reason code 9C on
any system on which CFRM is in use.
- R
- To request that XCF be reinitialized. XCF will stop using the
current couple data sets and issue message IXC207A to prompt the operator
for a new COUPLExx parmlib member.
If an incorrect reply is entered, the system issues
message IXC208I to notify the operator of the error. The system then
reissues message IXC222D.
Notify the system programmer.
System programmer response
This message indicates that the COUPLExx
parmlib member specifies a sysplex couple data set configuration that
is not the configuration currently or most recently used by the sysplex.
This could be caused by the removal of a primary or an alternate or
by the addition of a new alternate couple data set. Updating the COUPLExx
parmlib member to describe the in-use or last-used couple data set
configuration should eliminate this message.
Source
Cross System Coupling Facility (SCXCF)
Module
Routing code
Descriptor code