IXCH0510E

Explanation
         The current XCF Failure Detection Interval
is set to     fdi seconds.        This is higher/lower than
the checkowner_or_installation specification  of parm seconds
determined by equation      (parameter 1) * (system timeout value)
+ (parameter 2)  

System action
The system continues processing.

Operator response
Report this problem to the system programmer.

System programmer response
         Adjust system timeout value
or the XCF failure detection interval.  
         To adjust
the system timeout value issue SET EXS=xx at operating
  system console. Update the EXSPATxx parmlib member with SPINTIME=xx.

       To adjust the XCF Falure Detection Interval issue SETXCF
COUPLE,INTERVAL=xx at the operating system console. Update
the COUPLExx parmlib member with INTERVAL=xx. 

Problem determination
N/A

Source
         Parallel Sysplex® (XCF)          

Module
         IXCHCCPL   

Routing code
See note 35.

Descriptor code
3 is the default set by this check. See note
1.

Reference Documentation
 z/OS MVS Setting
Up a Sysplex
z/OS MVS Initialization and Tuning Guide 
z/OS
MVS Initialization and Tuning Reference