IXCH0109I

Explanation
The specified check is not applicable in the current
environment.
To perform the check, information must be obtained
from the CFRM active policy. The CFRM active policy resides on the
CFRM couple data set that cannot be accessed from the specified system.

 In the message text:check_owner
The owner of the check is IBMXCF.
check_name
The name of the check.
system_name
The name of the system.

System action
The specified system will discontinue running
the specified check. 

Operator response
Report this problem to the system programmer.

System programmer response
The CFRM active policy could not be
read to obtain information required by the named check because the
couple data set supporting TYPE CFRM is not accessible to the specified
system. 
Determine if the CFRM couple data set should be made
available to the system. To give the system access to the CFRM couple
data set, issue command SETXCF COUPLE,TYPE=CFRM,PCOUPLE=(data_set_name,volser).
When the CFRM couple data set is made available to any system in the
sysplex, IBM Health Checker for z/OS runs the check from one of those
systems. 
 When other systems in the sysplex have access to
the CFRM couple data set, IBM Health Checker for z/OS runs the check
from one of those systems. 
 When no system in the sysplex has
access to the CFRM couple data set, then use of coupling facilities
is not supported and the specified check remains disabled. 

Problem determination
N/A

Source
Parallel Sysplex® (XCF) 

Module
 IXCHCGR3 

Routing code
N/A

Descriptor code
N/A

Reference Documentation
 z/OS MVS Setting
Up a Sysplex