Explanation
An operator entered a SETXCF START|STOP,MSGBASED
command to specify the CFRM event management protocol.
In the
message text:
- START
- The request was to start message-based event processing.
- STOP
- The request was to stop message-based event processing (that is,
to revert to policy-based processing).
- (reason)
- CFRM COUPLE DATA SET IS NOT AVAILABLE
- The CFRM active policy could not be read because the couple data
set supporting CFRM is not accessible to this system.
- CFRM COUPLE DATA SET DOES NOT SUPPORT MESSAGE-BASED PROCESSING.
- The CFRM couple data set was not formatted at or above the minimum
version required for message-based event processing, and therefore
can support only policy-based processing.
To support message-based
event processing the CFRM couple data set should be formatted specifying
"ITEM NAME(MSGBASED) NUMBER(1)".
- ALREADY USING SPECIFIED PROTOCOL
- The requested event delivery protocol is already in use. For a
SETXCF START,MSGBASED command, message-based event processing is already
in effect. For a SETXCF STOP,MSGBASED command, policy-based event
processing is already in effect.
- AN UNEXPECTED ERROR OCCURRED
- An unexpected error occurred during command processing.
The results of the request are unpredictable.
System action
When the command completes successfully,
the system has updated the CFRM event management protocol as requested.
When the command fails, the event management protocol remains unchanged.
Operator response
If the request fails, report
the failure to the system programmer.
System programmer response
If the request fails
for reasons other than ALREADY USING SPECIFIED PROTOCOL, correct the
conditions that caused the failure as documented for the message reason
text, and reissue the command.
Source
Cross System Coupling Facility (SCXCF)
Module
Routing code
Descriptor code