Explanation
text is one of the following: - NO ONLINE OPERATIONAL PATHS
- RESERVE LOST
- ASSIGN LOST
- DISBAND AND REGROUP PATH GROUP FAILED
The system validated a dynamic pathing device, because
one of the following conditions occurred:
- The system detected a malfunction associated with the device.
- Either the operator or the system changed the state of one or
more channel paths to the device.
In the message text:
- dev
- The device number.
- NO ONLINE OPERATIONAL PATHS
- Validation found that there are no online channel paths that can
be used to access the device. This occurred for one of the following
reasons:
- Validation removed the last available online channel
path.
- Because of a channel path error, missing interrupt,
or non-operational channel path condition, validation could not obtain
data about the state of the channel path.
- RESERVE LOST
- Validation found that the device is not reserved to any channel
path from this system.
- ASSIGN LOST
- Validation found that the device is not assigned to any channel
path from this system.
- DISBAND AND REGROUP PATH GROUP FAILED
- Because of a channel path error, missing interrupt, or non-operational
channel path condition, validation could not obtain data about the
state of the channel path. The system could not remove the paths
by rebuilding the dynamic path group.
System action
The system boxes the device, as follows:
- The system ends I/O on the device.
- New I/O requests result in permanent I/O errors.
- The system performs no new allocations for the device.
- If the device was online, the system marks it pending offline.
A pending offline device goes offline when the following conditions
occur in this order:
- The device is no longer allocated to any job.
- Allocation can get the necessary resources to process the request.
- If the device was offline, it remains offline.
If the device is no longer allocated to a job, and if
allocation processing allocates any device in the system, the system
takes the device offline.
Operator response
To recover the boxed device, do the following:
- Vary the boxed device offline to all sharing systems.
- Isolate the failing control unit for repair.
- Determine the range of affected devices.
- Resynchronize dynamic path selection (DPS) array information for
all affected devices.
- Contact hardware support.
- Bring the device online to allow hardware support personnel to
verify the data on the boxed device. Do one of the following:
- Enter a DISPLAY UNITS command to see if the device is one of the
following:
- Offline and boxed (F-BOX)
- Allocated and boxed (A-BOX)
- If the device is offline and boxed, vary the device online by
entering the following command:
VARY dev,ONLINE
- If the device is allocated and boxed, display the using job steps
that are allocated to the device by entering the following command:
DISPLAY
U,,ALLOC,dev,1
Follow your installation's
procedures for unallocating using job steps.
Vary
the device offline, using the following command:
VARY dev,OFFLINE
Vary
the device online, using the following command:
VARY dev,ONLINE
- If the device is allocated and boxed, but not offline, enter the
following command:
VARY dev,ONLINE,UNCOND
- Verify the data on the volume.
- Identify and recover failing tasks.
Source
Input/output supervisor (IOS)
Module
Routing code
Descriptor code