Explanation
HyperSwap® Services detected a PPRC device error condition and are not able to complete the requested function.
In the message text:
- reason
- One of the following:
- PPRC secondary device is online, device
- The specified PPRC secondary device was found to be online. PPRC secondary devices must be offline to be monitored for HyperSwap.
- PPRC secondary device is not defined as a DASD device
- The specified PPRC secondary device is not defined as a DASD device.
- No operational paths to device
- The specified PPRC device was found to have no operational channel paths.
- Subchannel is not connected to device
- The specified PPRC device UCB was found to have no operational subchannel defined.
- Subchannel is unusable for device
- The specified PPRC device UCB was found to be unusable because of a permanent error condition.
- PPRC secondary device is boxed, device
- The specified PPRC secondary device was found to be in the boxed state and unusable.
- PPRC primary device is not defined as a DASD device
- The specified PPRC primary device is not defined as a DASD device.
- PPRC primary device is boxed, device
- The specified PPRC primary device was found to be in the boxed state and unusable.
- Dynamic Pathing is not initialized for PPRC Secondary device
- The specified PPRC secondary device was found to not have Dynamic Pathing established. The Hyperswap configuration may need to be purge and re-loaded.
Alternate subchannel set not consistent with other PPRC primary
devices
- The specified PPRC primary device had a different subchannel set
from other PPRC primary devices.
- Alternate subchannel set not consistent with other PPRC secondary
devices
- The specified PPRC secondary device had a different subchannel
set from other PPRC secondary devices.
- PPRC primary and secondary devices are both in alternate subchannel
sets
- Both a PPRC primary and a PPRC secondary device were found to
be in an alternate subchannel set. The primary device number is shown.
- devn
- The associated PPRC device number.
System action
The HyperSwap Services request is terminated.
Operator response
Follow installation procedure for reporting problems.
System programmer response
Correct the PPRC device configuration problem indicated. If you are unable to correct the problem, purge and re-load the Hyperswap Configuration. If you still are not able to resolve the problem, contact the IBM® Support Center.
Module
IOSHSAPI
Routing code
2
Descriptor code
6