Check results may be based on previous parameter values.
New parameters will take effect the next time control unit data is
gathered.
Explanation
This message is issued when one of the following
occurs for CHECK(IBMIOS,IOS_CMRTIME_MONITOR):
- Health Checker has started or restarted and has added this check.
- An UPDATE request was issued to change the parameters for this
check via the PARMS keyword.
- This check was previously INACTIVE and an ACTIVATE request was
issued.
- This check was previously DISABLED and then became ENABLED.
For all of the above cases, the check is performed and will report
an exception or success based on the previously defined parameter
values. These values may be the default parameter values in certain
cases. If an UPDATE request was issued, the new parameter values
will be used the next time control unit data is gathered. Note: It
may take up to a few minutes for check results to be determined based
on new parameter values.
System action
CHECK(IBMIOS,IOS_CMRTime_Monitor) reports an exception
or success using the previously defined parameter values. For an UPDATE
request, the next time control unit data is gathered, check analysis
will be done using the new parameter values.
Operator response
System programmer response
Problem determination
Source
Module
Routing code
Descriptor code
Automation
Reference Documentation
n/a