IEE101I

Explanation
In response to a SLIP SET command that uses the
LPAMOD or LPAEP parameter, the system could not locate the specified
module. Since it is possible that the module will be added to LPA
later, the system continues to process, with the trap inactive.
In
the message text: id
The SLIP trap identifier.
modname
The name of the load module or entry point specified via the LPAMOD
or LPAEP parameter.

System action
If the module is subsequently added to LPA, the
system will use the new address information about the specified load
module, and will update and activate the trap.

Operator response
If it is expected that the module might not
yet be in the LPA, no action is required. Otherwise make sure that
you specified the correct module name.

System programmer response
None.

Source
SLIP

Module
IEECB905