Explanation
For general information about message IEC161I, see the explanation for return code 001.
Specific information for this return code: SFI = 1: CLOSE detected that VSAM Record Management processing was in progress when the close was issued.
| SFI Hex Value | Description |
|---|---|
| X'000C0004' | Indicates the whole RPL feedback word that can be use to locate the error point of VSAM Record Management failure. |
System action
CLOSE processing does not begin for the data set. CLOSE returns to the caller with the ACB still OPEN, and a CLOSE return code in register 15 equals to 4. The error flag (ACBERFLG) in the ACB (access method block) for the data set is set to 185 (X'B9').
System action
CLOSE processing ends for the data set. The error flag (ACBERFLG) in the ACB (access method block) for the data set is set to 185 (X'B9').
Programmer response
Issue ENDREQ before re-issuing CLOSE.
No SFI: CLOSE detected an error in WRTBFR. I/O for the data set was not quiesced before WRTBFR TYPE=DS was issued by VSAM CLOSE.
Programmer response
Issue ENDREQ before issuing CLOSE. Correct the error and rerun the job.
Module
IDA0200B, IDA0200T
Routing code
11
Descriptor code
6