IEC161I (return code 078)
rc[(sfi)]-ccc,jjj, sss,ddname,dev,ser,xxx, dsname,cat

Explanation

For general information about message IEC161I, see the explanation for return code 001.

Specific information for this return code: The AMBL (access method block list) is incorrect, or the caller of EOV was not in supervisor state, or EOV for an AMB which had a previous EOV error, or
  • Invalid AMBL - AMBL address not in the VAT
  • Invalid IOMB - IOMB address not PLH not found in AMB IOMB chain.
  • Invalid BLDVRP/DLVRP parameter list.
  • Attempt to open a Catalog, System data set, or for GSR but not authorized, key 0-7, supervisor state.
  • ccc = 215 - EOV with AMBLESET=ON
  • ccc = 218 - Invalid AMB.

System action

CLOSE or EOV processing ends for the data set. CLOSE (TYPE=T operand) processing continues, if possible. The error flag (ACBERFLG) in the ACB (access method block) for the data set is set to 188 (X'BC'). Media Manager services sets ACBERFLG to 130 (X'82').

Programmer response

If the error occurred during CLOSE, CLOSE (TYPE=T), or EOV processing, correct the indicated error and resubmit the job.

Module

ICYMMSRV, IDA0192A, IDA0192F, IDA0192W, IDA0192Y, IDA0200B, IDA0200T, IDA0231B IDA0231T IDA0557A IDA0557D IDAV202T

Routing code

11

Descriptor code

6

Parent topic: IEC messages