Explanation
For general information about message IEC161I,
see the explanation for return code 001.
Specific information
for this return code: Invalid Extent information. Length of catalog
extent data does not match the number of extents, number of extents
is greater than the maximum number allowed, or extent out of sequence.
- ccc = 003 - IDA0192C: MERGVOL - Length of extent data does not
match number of extents.
- ccc = 026 - IDA0192Z:
- SFI 4- VSAM Open has detected greater than 255 extents exist for
this data set.
- SFI 5- VSAM Open has detected extent out of sequence condition
due to volume out of order for an index component of an SMS-managed
data set with at least one stripe.
- SFI 6- VSAM Open has detected extent out of sequence condition
due to volume out of order for a non-striped or non-SMS data set.
- SFI 7- VSAM Open has detected extent out of sequence condition
due to volume out of order for a data component of an SMS-managed
data set with at least one stripe.
- ccc = 032 - IDA0192C: MERGVOL- Open of a striped component - catalog
returned at least 1 volume entry with no extent information.
System action
SFI 5, SFI 6, and SFI 7 are warning messages and
OPEN processing continues. For all others, OPEN processing ends for
the data set. The error flag (ACBERFLG) in the ACB (access method
block) for the data set is set to 168 (X'A8').
Programmer response
For SFI 5, SFI 6, and SFI 7, no action is
necessary unless you want the volumes in order. If you want the volumes
in order, see informational APAR II14289. It documents an available
unsupported tool that identifies data sets with volumes out of order.
The tool scans specified catalogs and provides the correct volume
sequence for data sets.
For all other errors, correct the error
and rerun the job.
Module
IDA0192C, IDAV192Z, IDA0192Z
Routing code
Descriptor code