IEC161I (return code 048)

Explanation
For general information about message IEC161I,
see the explanation for return code 001.
Specific information
for this return code: The requested master or user catalog does not
exist or is not open.  The (sfi) field in the message is of the form
(rc, crs, cmi) where rc  - catalog return code
crs - catalog reason code
cmi - catalog module name that detected the error

See message IDC3009I for a list of these catalog return
and reason codes.
OR, RESET processing requested and the data
set is an INDEX component.

System action
OPEN, CLOSE, or EOV processing ends for the data
set.  CLOSE (TYPE=T operand) processing continues, if possible. The
error flag (ACBERFLG) in the ACB (access method block) for the data
set is set to 180 (X'B4').

Programmer response
If the error occurred during OPEN, CLOSE
(TYPE=T), or EOV processing, make sure that the correct catalog
is available (for example, the volume is online) and rerun the job. 
If the error occurred during CLOSE processing, make sure that the
correct catalog was not deleted and is open.  If the data set was
open for output, use the access method services VERIFY command to
make sure that the end-of-file marker in the data set entry in the
catalog is correct. Do this before trying any further processing on
the data set. If the data set was open for input, the VERIFY command
need not be used.

Module
IDA0192C, IDAV192C

Routing code
11

Descriptor code
6