IEC161I (return code 036)
rc[(sfi)]-ccc,jjj, sss,ddname,dev,ser,xxx, dsname,cat

Explanation

For general information about message IEC161I, see the explanation for return code 001.

Specific information for this return code: An I/O error was detected while the system was reading or writing a catalog record. The (sfi) field in the message is of the form (rc, crs, cmi) where
  • rc - catalog return code
  • crs - catalog reason code
  • cmi - catalog module name that detected the error

See message IDC3009I for a list of these catalog return and reason codes.

System action

OPEN, CLOSE, or EOV processing ends for the data set. CLOSE (TYPE=T operand) processing continues, if possible. The error flag (ACBERFLG) in the ACB (access method block) for the data set is set to 144 (X'90').

Programmer response

If the error occurred during OPEN, CLOSE (TYPE=T), or EOV processing, specify different device for the catalog that caused the problem and rerun the job. If the error occurred during CLOSE processing, and the data set was open for output, use the access method services VERIFY command to make sure that the end-of-file marker in the data set entry in the catalog is correct. Do this before trying any further processing on the data set. If the data set was opened for input, the VERIFY command need not be used.

Module

IDA0192C, IDA0557A, IDA0557B, IDAV192C, IDAV557A

Routing code

11

Descriptor code

6

Parent topic: IEC messages